RTR Accessories Technical Documentation
A repository for information related to the RTR accessories.
Installing the RTR Touch probe
Our touch probes are designed to use our macro to probe either X,Y,Z or just the Z axis. Click on the Installation button bellow to take you to the installation document and after you have it installed click on the setup button to see how to set it up and fine tune its actions.
Wireless handwheel intallation
-
Step 1
Install batteries in your wireless handwheel.
-
Step 2
Plug in your wireless handwheel's antenna.
-
Step 3
Don't turn on your handwheel just yet, we need to go into the settings and set it up. Close and reopen Planet CNC.
-
Step 4
Click on settings at the top center of the screen.
-
Step 4 Cont.
Click on "handwheel" on the left side of the settings screen.
-
Step 4 Cont.
Make sure Wireless Handwheel is enabled (check the circle if it didnt do it automatically). Make sure none of the steps are checked for modes 1-5.
-
Step 5
Set the speeds for Modes 1-5. Start with the following:
(Mode 1 - 1)
(Mode 2 - 5)
(Mode 3 - 25)
(Mode 4 - 100)
(Mode 5 - 250) -
Step 5 Cont.
Click the OK button.
-
Step 6
Turn off and on Planet CNC. Turn off and on the Wireless Handwheel (silver buttom at the top right).
The Wireless Handhweel should now display the work coordinates and allow you to jog the gantry and z axis. Use the left knob to select the axis you want to move and the right knob to select the axis's speed.
Opt Laser Tech Info
-
Base feeds and power settings
-
Laser tech info
Websites for learning how to use the laser.
-
Opt Laser's Website
https://optlasersgrav.com/plh3d-15w-engraving-laser-head
-
Opt Laser's YouTube page
https://www.youtube.com/c/OptLasers
-
Vectric Laser Module
https://www.vectric.com/products/laser-module
-
Opt Laser Facebook Users Group
https://www.facebook.com/groups/optlasers
-
ImagR
https://www.imag-r.com/
-
Opt Laser Facebook File section
https://www.facebook.com/groups/optlasers/files/docs
